21 replies to this topic

[BBoyPersia]

Will update with more details as I get them. These retail for $265, we sell them for $259.95. There will be a sale price of $239.99 + free shipping for a short time.
These are in stock and ready to ship.

https://www.highhors...oductCode=10300





 

*dont know the exact capacity, will update when i get more specs.

[1FST4DR]

What holds the filter in place?

[BBoyPersia]

theres an adapter

[Hemi31]

An adapter to hold it up or extend it down to the bottom of the pan?

[1FST4DR]

Actually I see how that works now.  thanks

[BBoyPersia]

An adapter to hold it up or extend it down to the bottom of the pan?

it extends it to the bottom of the pan, ill post a pic when i get a chance

[StevoHemi]

Nice looking product. I like. My ride is dropped... dunno if the deep pan is a good idea for me.

Stevo

[BBoyPersia]

Nice looking product. I like. My ride is dropped... dunno if the deep pan is a good idea for me.

Stevo

i might end up mocking it up on my car to see how the clearances are and take pics if noone gets it done before me.it shouldnt hang too much lower than the trans support

[BBoyPersia]

pic taken from the instructions

[StevoHemi]

Looking at the pic, I am guessing there is an additional 2 inches there. Been awhile since I have looked underneath my girl. I am hoping that something other than the new trans pan is lower such as k frame etc.

Stevo

[BBoyPersia]

how low does the trans brace sit? it might end up being same level

[StevoHemi]

I have the tubular Speedlogix trans brace made by Razors Edge. Looking at the third photo (side view), I cannot see the outside lip (can be seen in left pic of OE pan) of the pan which is used to mount the pan. Am I missing something?

 

Stevo

[BBoyPersia]

you mean the 6 clips/bolts that hold it to the trans? the gooves are built into the pan, factory mount area are there. the lip is the shiny spot in the middle in the 3rd pic

[MAGFX]

This shows a bit of the relationship with the tranny pan, cross member, and Kook's headers.

[budoboy]

Who makes it and is it BuilderBill approved?

[BuilderBill]

Who makes it and is it BuilderBill approved?

B&M and YES if it fits your application it is approved:)

All good.

Bill

[budoboy]

Thanks Bill!

[BBoyPersia]

kinda disappointed this came up right after i went through all the trouble to get my benz pan with the drain...

i wouldnt mind datalogging my transtemps

[BBoyPersia]

the b&m pan holds about 2.5 quarts more than stock

[MAGFX]

Did you just make that up?